Chapter 2: Before You Get Underway
Boat Maintenance
Keeping your boat well-maintained will extend its life and give
you and your family many more years of enjoyment.
- Examine the interior and exterior of the hull when it is out
of the water.
- Check for oxidation, a common problem on aluminum hulls,
that appears as white powder spots. Use fine sandpaper on
oxidized areas until spots are replaced by bright shiny metal.
- To protect the environment, use only environmentally safe,
non-phosphate detergents to remove oil and algae from fiberglass
hulls. Avoid abrasive materials, which can remove the shiny
top layer (gel coat). Patch holes immediately with a fiberglass
patching compound.
- Check through-hull fittings to make sure they are not cracked
or leaking.
- Remove all puddles from the interior before and after every
outing.
- Store boats in a dry area out of the sun. If you must store
the boat for a long period of time, place the trailer on blocks
to preserve the tires. Keep the boat covered, leaving an opening
to circulate air. Hang canoes upside down.
- Clean all lines (ropes). Dirt and sand cause deterioration.
Keep lines out of the sun when not in use, and replace weakened
or fraying lines.
- Clean sails with a soft brush. Examine them for small tears
or open seams that can be repaired by taping or sewing.
- Refer to the owner's manual for a maintenance schedule.
Engine Maintenance
Engine maintenance is important. Follow a regular maintenance
program.
- Keep your engine clean and tuned properly. Refer to your owner's
manual for a maintenance schedule.
- Check the oil and fluid levels before every outing. Change
the oil according to the owner's manual. As the engine ages,
increase the frequency of oil changes. Clean oil extends engine
life.
- Tighten battery connections. Clean battery terminals by disconnecting
the terminals and removing corrosion with a wire brush. If the
battery is weak when you start the engine, recharge it.
- Inspect the engine for anything that shows signs of wear or
requires tightening, such as hoses, belts, and bolts. Make sure
everything is fitted properly, including the engine cover.
- Never use automotive electrical parts. Use marine parts only.
Use of automotive parts rather than sealed marine parts (such
as alternators, starters, fuel pumps, and other electrical parts)
could cause a spark that could ignite a fire.
|
|

Find
Another
Boating Safety Course
|